eScan Blog
eScan Website
eScan Forum
eScan Feeds From eScan Wiki
(Difference between revisions)
| Revision as of 17:21, 26 June 2009 WikiSysop (Talk | contribs) ← Previous diff |
Revision as of 17:37, 26 June 2009 WikiSysop (Talk | contribs) Next diff → |
||
| Line 35: | Line 35: | ||
| To correct this, check the following | To correct this, check the following | ||
| + | |||
| + | [[Image:es-1.JPG|image|center]] | ||
| + | |||
| + | |||
| + | [[Image:es-2.JPG|image|center]] | ||
| + | |||
| + | [[Image:es-3.JPG|image|center]] | ||
| + | |||
| + | [[Image:es-4.JPG|image|center]] | ||
| + | |||
| + | [[Image:es-5.JPG|image|center]] | ||
| + | |||
| + | [[Image:es-6.JPG|image|center]] | ||
Revision as of 17:37, 26 June 2009
|
General |
Knowledgebase |
Support |
Q. When MWAV / Quick Scan is used to scan the system, scanning either gets stuck or takes longer time to scan.
A. This could happen to any Drive or Folder due to lack System rights required by MWAV using the IPC scanning.
[Note:- When MWAV (without any command line parameters) / Quick Scan is used to scan the system, it will use the IPC scanning (the title bar or MWAV / Quick Scan will display as "IPC").]
To correct this, check the following
